Mike9332

Hey y'all, posted this in the new member forum too, hope you don't mind it being in both.

I have a 2015 Wrangler 2 door and picked up a set of rear springs from my buddy a few days ago but can't figure out the height/rate. I know you go by the last two digits of the p/n, but these ones are 68196007AA, so I can't really tell. MOPAR site says they're from a 2014 Wrangler, but that's as far as I can find. Anyone have any ideas? Thanks!

larry0071

I'm shooting in the dark, but I am going to guess that they are equal to the older numbering sequence that would have been a 57 rear.

jadmt

10a or hardrock perhaps which would be good if looking for a little bumps.

Mike9332

I dug a bit more and found they are 10A's off a 2014. Swapped them with my stock 55s and Teraflex 1 inch puck and it came out pretty level to what it was before. Springs were about an inch taller when they were disassembled. Thanks!