Rough Country Manual Shifter Adapter issues....
#1
JK Newbie
Thread Starter
Join Date: Jan 2010
Location: Albright WV
Posts: 77
Likes: 0
Received 0 Likes
on
0 Posts
Rough Country Manual Shifter Adapter issues....
I recently got the 1.25" 2 door body lift with the manual shifter adapter from Rough Country and finally got around to starting the install since the temps outside aren't to bad. Anyways when I went to put the adapter on the transmission stub it didnt go on more than a little ways. I used a block of wood and tried a little bit of force and it went down a total of about a half of an inch. This led to about an hour of trying to get the damn thing back off the stub which I finally managed to do. I checked for burs on both the stub and adapter but nothing. Has anyone else had this issue with it not wanting to go down over the transmission stub?
Thanks
-Mallow
Thanks
-Mallow
#2
JK Enthusiast
Join Date: Mar 2011
Location: Odenton, MD
Posts: 227
Likes: 0
Received 0 Likes
on
0 Posts
Yes I had this same exact issue installing this on my 2011 JKU. I picked up a longer screw from the hardware store and used that, it slowly gets the adapter to go down further. But like you, I also spent about 30 mins wrestling with this thing trying to install it.
#7
JK Enthusiast
Join Date: Apr 2008
Location: Champaign, Illinois
Posts: 478
Likes: 0
Received 0 Likes
on
0 Posts
i installed this lift about a month ago on my 07 manual. i remember talking to the RC guy and he said that the opening for the 11s and possibly the 10s for the shifter to come through are more oval or something than earlier models. i had the issue of my jeep falling out of gear for about 30 mins. i didnt trim my shift boot. although it did have a small tear in it from something else. anyways.. to fix the falling out of gear issue.. i turned the shift knob adapter every so slightly so the it was facing the drivers seat a little bit. i have not since had the falling out of gear issue.
Trending Topics
#8
JK Newbie
Join Date: Feb 2013
Location: United States
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
I have an '11 and Im trying to install the adapter... I took the first screw out of the actual shift lever, but it will not come off the tranny shaft!? How did you all get the shift lever off the shaft to even try and install the adapter onto in? Thanks!!
#9
JK Freak
Join Date: Sep 2009
Location: long island,New York
Posts: 803
Likes: 0
Received 0 Likes
on
0 Posts
I couldn't get the adapter all the way down on my 2009, I ended up hitting it as far a I could get it to go. Then I got a longer screw from the hardware store.