Nitro sleeves + BFH = Successfully strengthening axles?
#42
^^^^ What he said! Smooth end first. The ribbed end should be closest to your tires. Believe me, when the ribbed in starts going in, those last couple of inches are going to be a PIA to hammer in.
#45
JK Forum Regional Rep
Join Date: Jan 2011
Location: Stockton.Ca
Posts: 2,921
Likes: 0
Received 0 Likes
on
0 Posts
[h=3]Nitro Sleeve Install Party (Day 2 with custom tools)Hey guys check this out,watch the video.We did 7 of these sleeves in 2 days[/h]
#48
JK Jedi
Wow, the tool is key!! I watched the video without listening to the sound (didn't want to get busted... lol). I will watch and listen again. Hopefully it describes what's on the end of the tool that you guys built.
#49
JK Forum Regional Rep
Join Date: Jan 2011
Location: Stockton.Ca
Posts: 2,921
Likes: 0
Received 0 Likes
on
0 Posts
It's the bearing driver with the wider end facing the sleeve.I stacked some washers that measured the same ID as the sleeve to keep from moving around.I built this tool because the first attempts using the required tool failed in a short time.