ANYONE SEEN THIS
cgi.ebay.com/ebaymotors/Jeep-Wrangler-2007-JK-Winch-Bumper-with-Brush-Guard_W0QQitemZ110107986280QQcategoryZ33640QQrdZ1Q QcmdZViewItem

 

Thats a good looking bumper for 350.00. Does anyone know about quality?


Thanks
Mountjk

 

Looks good, I think I would have put the D rings a little closer to the frame rails for more strenght.

 

Looks good. Price is nice too.

 

as it states in the auction

"All our bumpers come bare steel."


cutting Powercoating is cutting a huge cost esp if they dont have the means to do it themself and have to sub it out.

 

nothing a little line-x couldn't fix.

 

Me neither. Too much going on up front. Maybe eliminate the grill guard bars attached to the already existing grill guard down the middle there.

 

it's one of the better looking bumpers i've seen so far. it makes me happy that garage fabricators are starting up now. i'd rather the grill hoop came up like a stinger, or really high pre-runner. i like the supports going down the side, and that they incorporate the factory fogs. i'm not sure i'd use those clevis mounts as recovery points though. those are really close to the ends...

 

here you go.

 

not too bad overall.

would like to see:
a tad narrower
D-ring mounts nearer the frame rails
and bend the ends back some, so it isn't so flat.