My Mw3 Build,
04-14-2014 | 04:44 PM
#1
Thread Starter
JK Newbie
Joined: Oct 2012
Posts: 50
Likes: 0
From: gibson city il
My Mw3 Build,
So after two years of acquiring parts a little bit at a time I finally took my jeep into the shop today and I'm PUMPED! So here's my build sheet. AEV 4.5" Dualsport RS lift,AEV fuel caddy and spare tire carrier, AEV water tank and pump kit, 4.88 Yukon gears and timken bearings, T era flex sleeve and gusset kit, Garvin rock sliders and 37" KM2's on matte black Hutchinson rockmonsters! wish it was left in the budget for the new front bumper and warn winch but not right now.i hope this is a reliable setup and should have pics on here end of the week,
Sent from my iPad using JK-Forum
Sent from my iPad using JK-Forum
04-24-2014 | 08:27 PM
#4
Thread Starter
JK Newbie
Joined: Oct 2012
Posts: 50
Likes: 0
From: gibson city il
So after two years of acquiring parts a little bit at a time I finally took my jeep into the shop today and I'm PUMPED! So here's my build sheet. AEV 4.5" Dualsport RS lift,AEV fuel caddy and spare tire carrier, AEV water tank and pump kit, 4.88 Yukon gears and timken bearings, T era flex sleeve and gusset kit, Garvin rock sliders and 37" KM2's on matte black Hutchinson rockmonsters! wish it was left in the budget for the new front bumper and warn winch but not right now.i hope this is a reliable setup and should have pics on here end of the week,
Sent from my iPad using JK-Forum
Sent from my iPad using JK-Forum