Originally Posted by kraxler

I have five boxes of the 3.5 ARB lift sitting in my garage just waiting to be installed

Originally Posted by Rob50lx

I thought the front springs only go in one way. I thought there was a locating tab on the bottom spring pad that kept the spring from rotating and staying in a specific position.

Sent from my d2lte using Tapatalk

Originally Posted by Invest2m4

This would be correct.

Originally Posted by BigMike

There was on my '09 but not on my '14. The tab is usually at about 12:00 which is where I initially set the end of the coil.

The spring was a sumbitch to turn even with the driver's side jacked up and the axle drooping.

Originally Posted by jnabird333

I have done two lifts on 14's and there was a notch in the lower perch to orient the coil same as there was on my 13', the 07', (2) 09's, and a 11' I have had the coils out on.

Originally Posted by Invest2m4

Yeah, I have to agree again. Just put a GC ARB on a 2014 Rubi X and the perch was the same as my 2013 - had the locating tab. Located at the back side (rearward side).

Originally Posted by Invest2m4

Thought I'd post a couple pics from the weekend to tease those waiting to install their kit. Last pic took 7 Jeeps to recover the guy from what would have been a near death fall.

<img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=559045"/><img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=559046"/><img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=559047"/><img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=559048"/>

Originally Posted by JayswranglerX

See where a Bronco will get ya....lol Cool shots man Sent from my LG-LS980 using JK-Forum