Metalcloak Thread
#1092
Anyone have measurements of the 3.5 coils? These aren't THAT much longer than stock. Pic of the front coils.
Just checking since I know some were shipped 2.5 coils instead of 3.5.
Just checking since I know some were shipped 2.5 coils instead of 3.5.
#1093
You can't go by comparing them. Look at the bottom winding on the stock coil (end code) you loose 2-3" installed in the jeep.
#1094
I spent Forever reading over this whole thread! Lots of pointless arguing, lots of meatheads. But a few voices of clarity and knowledgable people. I learned a ton about roll center. Great read! A few worries also with dirtmans broken Ca and the "tail wag" on the new taller bracket. We will see what happens. I hope my kit comes with the new forged ends!?!?
I dont always drive where others cant. but when I do, its in my Jeep. Stay muddy my friends
I dont always drive where others cant. but when I do, its in my Jeep. Stay muddy my friends
#1096
JK Jedi
The metal cloak will also compress less then the factory coils when installed due to the increased coil rate.
#1097
JK Enthusiast
Ordered my kit last week. Got the basic 3.5" one, however added the rear brake lines, and lower control arms (so will have both lower/upper front control arms). Will do the rest of the arms later on. On a side note... exchange rate sucks right now... should have ordered mine last summer.
#1098
Ordered my kit last week. Got the basic 3.5" one, however added the rear brake lines, and lower control arms (so will have both lower/upper front control arms). Will do the rest of the arms later on. On a side note... exchange rate sucks right now... should have ordered mine last summer.
I dont always drive where others cant. but when I do, its in my Jeep. Stay muddy my friends
#1099
JK Enthusiast
Jealous. With the exchange rate, shipping was close to $400. Sometimes living in the north sucks.