Low-cost / Free mods that should be done?
#2751
JK Junkie
Anyone came up with a way to space out the freedom tops to run them without the hardtop? I'm thinking of using a 6 inch piece of 2x4, covered in the non slip tool box drawer liner, with a hole drilled through it. I figure this should help distribute out the load, and keep the wood from scratching anything. Best I can measure the top adds in an offset of about 1.75 inches, which is why I thought a 2x4 would work well.
#2754
Sent from my DROID RAZR using Tapatalk 2
#2755
JK Junkie
See this thread: https://www.jk-forum.com/forums/stoc...t-panels-4511/
#2756
JK Enthusiast
Bullfrog
#2758
JK Enthusiast
Anyone came up with a way to space out the freedom tops to run them without the hardtop? I'm thinking of using a 6 inch piece of 2x4, covered in the non slip tool box drawer liner, with a hole drilled through it. I figure this should help distribute out the load, and keep the wood from scratching anything. Best I can measure the top adds in an offset of about 1.75 inches, which is why I thought a 2x4 would work well.
Sent from my SGH-T959 using Tapatalk 2