Longer ABS sensor cable?
#1
JK Freak
Thread Starter
Longer ABS sensor cable?
I am looking for a compatible wheel speed sensors that has a longer cable but same sensor on the wheel end and cable connection end as stock.
I have seen them on other rigs but have not been able to get a part number or the vehicle and year they came from. Any help would be appreciated.
I have seen them on other rigs but have not been able to get a part number or the vehicle and year they came from. Any help would be appreciated.
#3
I am looking for a compatible wheel speed sensors that has a longer cable but same sensor on the wheel end and cable connection end as stock.
I have seen them on other rigs but have not been able to get a part number or the vehicle and year they came from. Any help would be appreciated.
I have seen them on other rigs but have not been able to get a part number or the vehicle and year they came from. Any help would be appreciated.
#4
JK Junkie
Are yours still connected to the steel bracket on the lower coil perch? If so, ditch that bracket and you'll gain a lot.
Agree that the cables coming on replacement unit bearings are short.
Lastly, I'll state the obvious. If your cables are not in the bracket and really are too short, just splice some wire in to lengthen them. About as easy as it gets.
Agree that the cables coming on replacement unit bearings are short.
Lastly, I'll state the obvious. If your cables are not in the bracket and really are too short, just splice some wire in to lengthen them. About as easy as it gets.
#5
JK Freak
Thread Starter
Since my old axles were sold with the sensors, and i installed dana 80s front and rear and dont have a sensor at all! So if im gonna buy some-why not find a longer pair to begin with? Thats why i asked
#6
JK Junkie
For nearly $20k, you'd think Dynatrac could toss in some speed sensor cables....
#7
JK Enthusiast
Join Date: Dec 2009
Location: Marquette, MI
Posts: 138
Likes: 0
Received 0 Likes
on
0 Posts
Check out aeromotive they make a Jeep Wrangler specific plug & play abs sensor wire extenders... Slick, i believe if i remember correctly they are 12" extra length... Perfect for my application. I started to do the splice and extend, but got into it and decided it was just too much and even with my "perfection" attitude it seamed like a hack job... Liked the extender route and they are water proof...
Trending Topics
#10
JK Junkie
This is what comes stock on new JKs. My stock cable was notably longer than the one that came on a new front bearing.
http://www.amazon.com/Genuine-Chrysl.../dp/B00FSDUZ54.
http://www.amazon.com/Genuine-Chrysl.../dp/B00FSDUZ54.