Installing 5.13 gears, need your opinion on gear pattern!
#1
JK Newbie
Thread Starter
Join Date: Mar 2007
Location: Boras, Sweden
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
Installing 5.13 gears, need your opinion on gear pattern!
Hi guys!
This is the first time I'm installing new gears. My Jeep is a Wrangler Unlimited Rubicon 2008. I would like your opinion on my gear patterns before moving on with the installation.
First try:
Then I added a 0.1mm pinion shim:
What do You think? Is this enough or should I add another 0.1mm?
It was very easy to mount the ring gear after it was heated. I baked a nice pie at the same time
This is the first time I'm installing new gears. My Jeep is a Wrangler Unlimited Rubicon 2008. I would like your opinion on my gear patterns before moving on with the installation.
First try:
Then I added a 0.1mm pinion shim:
What do You think? Is this enough or should I add another 0.1mm?
It was very easy to mount the ring gear after it was heated. I baked a nice pie at the same time
#4
JK Enthusiast
Join Date: Apr 2011
Location: Ranch Santa Margarita, CA
Posts: 356
Likes: 0
Received 0 Likes
on
0 Posts
I am certainly no expert but from what I can see it looks good. Looks centered on both sides. How did the rest of the install go? So what kind of pie is it?
#5
JK Newbie
Thread Starter
Join Date: Mar 2007
Location: Boras, Sweden
Posts: 21
Likes: 0
Received 0 Likes
on
0 Posts
I started with the rear axle today, will finish it tomorrow. Just wanted some opinions before proceeding.
I baked a pineapple pie, tasted very good with some wipped cream! :-)
More opinions please.
Thanks again.
I baked a pineapple pie, tasted very good with some wipped cream! :-)
More opinions please.
Thanks again.