Installing 4 inch TF with control arms..
10-12-2009, 09:23 AM
#1
JK Enthusiast
Thread Starter
Join Date: Feb 2009
Location: farmington nm
Posts: 234
Likes: 0
Received 0 Likes
on
0 Posts
Installing 4 inch TF with control arms..
Any tips on installing this kit. I was looking for a write up on it but couldnt seem to find it anywhere. ANyone who has any tips please share... I am replacing the front drive shaft and leaving the rear alone. It is on my 07 Unlimited Rubicon. On the instructions on the control arms it shows measurements for the stock driveshafts but not for the aftermarked front. Let me know.. Thanks..
10-12-2009, 09:44 AM
#2
JK Freak
Join Date: Jun 2009
Location: Monterey, CA
Posts: 662
Likes: 0
Received 0 Likes
on
0 Posts
It's all right here
http://project-jk.com/jeep-jk-write-...ation-write-up
I used this to do my 3" TF kit and it made it very "easy". Don't get me wrong, it's was very time consuming but straight forward.
http://project-jk.com/jeep-jk-write-...ation-write-up
I used this to do my 3" TF kit and it made it very "easy". Don't get me wrong, it's was very time consuming but straight forward.