Have aftermaket CV shafts? We need some help
02-03-2009, 09:16 AM
#1
Sponsoring Vendor
Thread Starter
Have aftermaket CV shafts? We need some help
If you have 1310 CV shafts W/ yokes installed we would like you to take a few measurments for us if you would.
I need the measurement from Center of U-joint on the axle to the center of u-joint on the Transfercase. Front and rear .
The center of the u-joint is also the flat surface of the yoke.
Please include these items .
2 door or 4 door
How much lift
Front or Rear
Thank-you
David
I need the measurement from Center of U-joint on the axle to the center of u-joint on the Transfercase. Front and rear .
The center of the u-joint is also the flat surface of the yoke.
Please include these items .
2 door or 4 door
How much lift
Front or Rear
Thank-you
David
Last edited by wayoflife; 02-03-2009 at 03:13 PM.
02-03-2009, 11:59 AM
#6
I wish I had seen this before I left home an hour ago. I have a 1310 rear drive shaft sitting in my dining room floor. When I get home I can measure the piss out of it if no one has done it before hand. It would be in my Jeep, but the guy that sold it to me is a big liar. He told me it was a 1350 shaft. And the front one he sold me is busted to pieces. I cannot measure the front since it is at the driveshaft shop getting rebuilt.
Hey david, those OEM style J.E. Reels shafts are not supposed to come with all the flanges and stuff that the 1350 ones do, right? Don't you just unbolt the original and bolt up the new one. Man I hate liars.
Hey david, those OEM style J.E. Reels shafts are not supposed to come with all the flanges and stuff that the 1350 ones do, right? Don't you just unbolt the original and bolt up the new one. Man I hate liars.
Trending Topics
02-03-2009, 12:48 PM
#8
Sponsoring Vendor
Thread Starter
I wish I had seen this before I left home an hour ago. I have a 1310 rear drive shaft sitting in my dining room floor. When I get home I can measure the piss out of it if no one has done it before hand. It would be in my Jeep, but the guy that sold it to me is a big liar. He told me it was a 1350 shaft. And the front one he sold me is busted to pieces. I cannot measure the front since it is at the driveshaft shop getting rebuilt.
Hey david, those OEM style J.E. Reels shafts are not supposed to come with all the flanges and stuff that the 1350 ones do, right? Don't you just unbolt the original and bolt up the new one. Man I hate liars.
__________________
Hey david, those OEM style J.E. Reels shafts are not supposed to come with all the flanges and stuff that the 1350 ones do, right? Don't you just unbolt the original and bolt up the new one. Man I hate liars.
__________________
1350 come with new flanges.
1310 HD come with yokes.
David
02-03-2009, 12:48 PM
#10
thanks. I am pretty sure those are what he sent me. He told me they were 1350s with less than 3k miles on them. He sent me one that looks refurbished, and one that had the socket that ball goes into on the cv joint completely bashed out. It is rusted and crap. and the U-joints in it are only 1310s. I hope they bolt up to my factory flanges. Just remember it is buyer beware in the for sale section.