Getting Aligned after lift tomorow - Need specs
#1
JK Super Freak
Thread Starter
Join Date: May 2008
Location: Grand Junction, CO
Posts: 1,279
Likes: 0
Received 0 Likes
on
0 Posts
Getting Aligned after lift tomorow - Need specs
I'm going to take my 08 Rubi 4dr in for alignment tomorrow. It's got a RE 3.5 SF lift (that netted 4 13/16 in front and 3 1/2 in back) and 35" KM2's.
From what I gather I should have them bump the toe-in from 1/16 to 1/8.
And I recall reading that factory caster was 4.2 and that I should go to 6. I have read that 6-7 is OK but that if going with aftermarket driveshafts I should use 6 as a max. While I still have the stock driveshafts I have a set of JE Reel 1350's on a truck on the way.
Am I correct or do I need to do something different?
From what I gather I should have them bump the toe-in from 1/16 to 1/8.
And I recall reading that factory caster was 4.2 and that I should go to 6. I have read that 6-7 is OK but that if going with aftermarket driveshafts I should use 6 as a max. While I still have the stock driveshafts I have a set of JE Reel 1350's on a truck on the way.
Am I correct or do I need to do something different?