Front driveshaft with budget boost and trackbar
#1
JK Super Freak
Thread Starter
I'm on a teraflex 2.5 BB and slightly taller front springs (from a 4 door to counter balance my winch). I just installed a synergy trackbar and now I have driveshaft clearance issues with my auto trans pan. It's an '08 2 door. AEV no longer sells their aftermarket rzeppa driveshafts. What's my best option? I'm not tall enough to warrant control arms so I want to keep those stock. I also don't want to run drop brackets. Are there any driveshafts I can run without adjustable control arms? Thanks. -Jordan
Last edited by AirJordan613; 07-11-2014 at 12:49 PM.
#2
Do you have any ideal what your pinion angle is now ? With 2/12" lift prob around 11/2* max. I would think any after market DS would be fine.
Just have to be mindful of any vibration due to pinion angle and TC joint, but doubt you have any probs...DS.Adams, coast, JE Reel, Tom Woods.
Just have to be mindful of any vibration due to pinion angle and TC joint, but doubt you have any probs...DS.Adams, coast, JE Reel, Tom Woods.
#3
JK Super Freak
Thread Starter
Do you have any ideal what your pinion angle is now ? With 2/12" lift prob around 11/2* max. I would think any after market DS would be fine.
Just have to be mindful of any vibration due to pinion angle and TC joint, but doubt you have any probs...DS.Adams, coast, JE Reel, Tom Woods.
Just have to be mindful of any vibration due to pinion angle and TC joint, but doubt you have any probs...DS.Adams, coast, JE Reel, Tom Woods.
#4
JK Super Freak
Thread Starter
Any other thoughts? I spoke with coast who said I could run their driveshaft with the factory arms
Last edited by AirJordan613; 07-12-2014 at 08:16 AM.
#5
#6
JK Super Freak
Thread Starter