Exhaust upgrade?
#2
axle back
I just got a flowmaster 50 delta flow. pipe starts right in front of rear axle and exits almost where stock did...just a little higher. $175 out the door installed.....good low sound, no interior resonance, and tucked up out of the way alot more than the stock muffler..
#3
JK Enthusiast
Well. I went with this one:
http://www.quadratec.com/products/17605_1204_07.htm
and you can see and hear from my thread created.
https://www.jk-forum.com/forums/show...ust-as-a-video
http://www.quadratec.com/products/17605_1204_07.htm
and you can see and hear from my thread created.
https://www.jk-forum.com/forums/show...ust-as-a-video
#4
JK Enthusiast
The MBRP has a deep tone but its very quiet. Its a nice tone in the morning. but you cant hear it when driving.
#5
JK Enthusiast
Join Date: Aug 2009
Location: La Quinta, Ca.
Posts: 367
Likes: 0
Received 0 Likes
on
0 Posts
#7
JK Enthusiast
Nice man! taking the muffler off is probably the loudest the JK will ever sound! Nice, keep us updated on the new exhaust sound and install please. im def looking for a louder sound!
pluke -
pluke -
Trending Topics
#8
JK Newbie
Thread Starter
Join Date: Aug 2010
Location: Alameda CA
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
Was just looking at my exhaust very simple to take off the muffler might go do that here in a few min. What is the best way to get the rubber hangers off with out destroying them?
#10
JK Super Freak
Join Date: Feb 2008
Location: Memphis, TN
Posts: 1,262
Likes: 0
Received 0 Likes
on
0 Posts
it was more of a pain in the butt than I expected to not kill the rubbers but I used a set of channel locks and bit on the back of the rubber with the front teeth of the channel locks on the hanger stud and then just squeezed the channy's to get the rubber over the lip. only took a few mins and there was some effort on wiggling the muffler to get it off the pipe, do it when it's cold....it would probly separate easier hot but hot vs. skin, hot has beaten me every time!!!