diy front bumper
#1
JK Junkie
Thread Starter
diy front bumper
Hey folks im at work and building a stubby bumper, i got measurements before i left the house for the mounting brackets but neglected to write down the bolt size and the spacing for the 4 bolts... Anyone wanna take 5 minutes and shoot me that info??? I left the jeep at home and my wife doesnt savvy what im askin her
Any help would be much appreciated.
Any help would be much appreciated.
#2
Super Moderator
Have you tried looking on LOD for their instiallation for their front bumpers. the botls are 18mm so I would say about 3/4 of an inch. Ok from the frame measuer over 1.25 inches and from the bottom 1.375 inches. Center to center of bots are 2.25 inches. It looks like the bolts are 1/2 inch in diameter. I would use a 5/8 in drill bit so you can adjust if my measurements are off. Hope this helps. Please keep me posted on the progress.
R/
Will
R/
Will
Trending Topics
#8
JK Junkie
Thread Starter
Thanks, I have someone that will bedline it for cheap but he is going to do the inside of the jeep in a couple weeks, then he can do it all at once. Plastidip comes off easy enough, and i spend 12 hours at work sitting on ass so if i need to re-do anything i can. trying to find a design for the rear bumper as well
#10
Thanks, I have someone that will bedline it for cheap but he is going to do the inside of the jeep in a couple weeks, then he can do it all at once. Plastidip comes off easy enough, and i spend 12 hours at work sitting on ass so if i need to re-do anything i can. trying to find a design for the rear bumper as well