Chromoly shafts for rear- what brand?
#1
JK Freak
Thread Starter
Chromoly shafts for rear- what brand?
Bought a yukon grizzly locker for my rear d44 and looking to install some chromoly shafts to strengthen the axle before I lock it this upcoming spring. Any suggestions on a chromoly shaft?
Any word on how the yukon chromoly shafts hold up?
I've heard good things about ten factory but that's about it.
Any suggestions before I pull the trigger?
Any word on how the yukon chromoly shafts hold up?
I've heard good things about ten factory but that's about it.
Any suggestions before I pull the trigger?
#4
JK Super Freak
Join Date: Jun 2011
Location: Bradenton, FL
Posts: 1,441
Likes: 0
Received 0 Likes
on
0 Posts
#5
JK Jedi Master
Join Date: Jan 2008
Location: Austin <--> Colorado Springs
Posts: 11,463
Likes: 0
Received 162 Likes
on
154 Posts
Yukons are shipped at generic lengths, then you cut them to fit your application. Choice of metals, and triple drilled, which could be a big plus. My local gear shop is a yukon preferred vendor, so those were his first suggestion when I was looking. After the work for cutting to length and pressing the bearings, they priced out about $100 higher than TenFactory.
TenFactory - 4140, 10yr warranty that includes bent flanges, dual drilled. Can be found for $310 or so if you look around, but mostly up in the $375+ range. (plus pressing the bearings)
G2 - exact same stats and warranty as TenFactory, they even buy direct from Ten when they run out of their own shafts. You will find these for $295
Nitro - 4130, 5 year warranty. Does NOT include bent flanges, void if bent/twisted/worn, this only covers an actual shaft breakage. Triple drilled. $450, but the plus for them is that they come pre-assembled, so you don't have the extra cost of pressing the bearings on.
Alloy Usa - 4140, dual drilled, 10 year warranty, (but no reply from them on what exactly is covered.) $360ish
Two months ago when I was looking, the G2's were on a nationwide backorder, so I ordered TenFactory. (a warranty is worthless if you can't replace a broken shaft, right?) Haven't followed it long enough to know whether it is a one-time shortage or on-going.
TenFactory - 4140, 10yr warranty that includes bent flanges, dual drilled. Can be found for $310 or so if you look around, but mostly up in the $375+ range. (plus pressing the bearings)
G2 - exact same stats and warranty as TenFactory, they even buy direct from Ten when they run out of their own shafts. You will find these for $295
Nitro - 4130, 5 year warranty. Does NOT include bent flanges, void if bent/twisted/worn, this only covers an actual shaft breakage. Triple drilled. $450, but the plus for them is that they come pre-assembled, so you don't have the extra cost of pressing the bearings on.
Alloy Usa - 4140, dual drilled, 10 year warranty, (but no reply from them on what exactly is covered.) $360ish
Two months ago when I was looking, the G2's were on a nationwide backorder, so I ordered TenFactory. (a warranty is worthless if you can't replace a broken shaft, right?) Haven't followed it long enough to know whether it is a one-time shortage or on-going.
Last edited by nthinuf; 12-02-2013 at 12:20 PM.
#7
JK Super Freak
Join Date: Jun 2011
Location: Bradenton, FL
Posts: 1,441
Likes: 0
Received 0 Likes
on
0 Posts