C Gussetts
#1
JK Enthusiast
Thread Starter
C Gussetts
What brands do you prefer?
Who had them welded with out taking everything apart?
can you weld them on with the coil spring in place? I was thinking jack jeep up take off tire and keep wet rags in places to help slow heat down..Any input would be helpful
Who had them welded with out taking everything apart?
can you weld them on with the coil spring in place? I was thinking jack jeep up take off tire and keep wet rags in places to help slow heat down..Any input would be helpful
#4
It only took a couple hours to yank the housing out. I installed sleeves and gussets at once.
I don't see how you can weld them all the way around without at least pulling the spring out. I use mig, not stick.
I don't see how you can weld them all the way around without at least pulling the spring out. I use mig, not stick.
Last edited by bbrown626; 10-20-2011 at 07:04 PM.
Trending Topics
#8
JK Enthusiast
Join Date: Dec 2008
Location: Albuquerque, NM
Posts: 422
Likes: 0
Received 0 Likes
on
0 Posts
#9
I did the EVO Cs. No need to take the springs out or the ball joints, go slow with wet rags as stated above. I also welded on some lower CA skids from EVO at the same time. About an hour for it all.