Bent Rock Hard Skid Plate
#1
JK Newbie
Thread Starter
Join Date: Aug 2015
Location: Denver, CO
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
Bent Rock Hard Skid Plate
So I clocked my engine skid pretty good on my last outing. Glad it wasn't the exhaust!
This is what it looks like when viewed from the side, the extension piece is no longer flush with the frame.
I think the little extension piece is actually OK, just misaligned because of the dent on the larger piece. Is there an easy way (i.e. without removing it) to bend this back into place? Hard to swing a hammer in a confined area like that. Or should I just leave it? It cost me 8 hours and some bent hole punches to get the system in place, and I'm afraid if I even take one bolt out it'll turn into a nightmare again.
This is what it looks like when viewed from the side, the extension piece is no longer flush with the frame.
I think the little extension piece is actually OK, just misaligned because of the dent on the larger piece. Is there an easy way (i.e. without removing it) to bend this back into place? Hard to swing a hammer in a confined area like that. Or should I just leave it? It cost me 8 hours and some bent hole punches to get the system in place, and I'm afraid if I even take one bolt out it'll turn into a nightmare again.