Beefing up dana 30
#1
JK Enthusiast
Thread Starter
Join Date: Jan 2011
Location: Dayton, Ohio
Posts: 214
Likes: 0
Received 0 Likes
on
0 Posts
Beefing up dana 30
I am looking at building up my Dana 30 front axle on my 2007 sahara unlimited. I am planning on the Artec Industries JK Front Axle Truss
as well as the EVO: Gussets/Brackets, EVO Mfg 44 Magnum Sealed JK/TJ Axle Sleeves.
My question is can these two products be combined and what else should I look into for a stronger axle.
as well as the EVO: Gussets/Brackets, EVO Mfg 44 Magnum Sealed JK/TJ Axle Sleeves.
My question is can these two products be combined and what else should I look into for a stronger axle.
#3
x2 on the Nitro Sleeves, no drilling and welding required. C Gussets are a must if you plan on running larger tires/wheels. I'm waiting for chromoly shafts until my factory shafts break. Truss kit would be a little over the top if you are putting in a sleeve IMO.
#4
JK Forum Regional Rep
Join Date: Jan 2011
Location: Stockton.Ca
Posts: 2,921
Likes: 0
Received 0 Likes
on
0 Posts
The axle housing truss/sleeves will take care of the housing.Running them both together may seem overkill to some.The weak point is the axle shafts and u-joints,replace with chromoly axles with full ring heavy duty u-joints
#6
#7
Former Vendor
Join Date: Oct 2012
Location: Newton, NJ
Posts: 1,615
Likes: 0
Received 0 Likes
on
0 Posts
They sell it with and with out. Here is a link for the kit that has the c gussets.
Artec JK Front Axle ARMOR KIT
Artec JK Front Axle ARMOR KIT
Trending Topics
#8
You do all your own welding when installing the truss/ gussets? Anything tricky?
#9
Former Vendor
Join Date: Oct 2012
Location: Newton, NJ
Posts: 1,615
Likes: 0
Received 0 Likes
on
0 Posts
If you upgrade your axle shafts and u-joints then your weak point becomes your pinion gear. I'd rather break a u-joint or axle than a pinion gear.