Anyone running the Rugged Ridge RRC Side Armor Guards?
02-01-2008, 05:30 PM
#1
JK Super Freak
Thread Starter
Join Date: Dec 2007
Location: Los Angeles, CA.
Posts: 1,258
Likes: 0
Received 0 Likes
on
0 Posts
Anyone running the Rugged Ridge RRC Side Armor Guards?
What up all?
Just perusing the wonderful JK goodies at Quadratec and stumbled upon these:
http://www.quadratec.com/products/12052_600_07.htm
Anybody running these Rugged Ridge RRCs? 300 bones is a steal for rocker guards...I just wonder how stout they are
(direct bolt on...no drill). Feedback would be greatly appreciated.
Russ D.
Just perusing the wonderful JK goodies at Quadratec and stumbled upon these:
http://www.quadratec.com/products/12052_600_07.htm
Anybody running these Rugged Ridge RRCs? 300 bones is a steal for rocker guards...I just wonder how stout they are
(direct bolt on...no drill). Feedback would be greatly appreciated. Russ D.
02-02-2008, 04:18 PM
#2
JK Enthusiast
Join Date: Dec 2007
Location: reading, pa
Posts: 474
Likes: 0
Received 0 Likes
on
0 Posts
these things do look good don t they! my wife wont let me get sliders, but she likes these cause they are kinda like a step too. i think i found a post on them and people said they were pretty good.
02-02-2008, 06:37 PM
#3
JK Super Freak
Thread Starter
Join Date: Dec 2007
Location: Los Angeles, CA.
Posts: 1,258
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the input, G. I was looking at the install instructions and they actually seem pretty sturdy, and like I said, for 300 bones...that's about 200 less than the nearest competitors. I might take a chance on them as well. If they break, at least it only cost 3 Benjamins...instead of 5!
Russ D.
Russ D.