Looking into Adams driveshafts. Anyone running these? I know they use good joints and the price is right. Also come with a lifetime warranty

 

They are local so a bunch of us in our club run Adams and many of us have had work done at his shop. James is a great guy and they do top notch work. I've yet to hear of an issue with their shaft.

 

Good to know. I just spoke to Kevin at Adams and he seems to be a cool cat. I just ordered front and rear. I just need to call him back with some measurements.

 

Are these driveshafts easy to obtain and install like Coast or JE? Or do you have to take measurements and send the information to them like when you order Tom Woods? If they are plug and play like Coast and JE then I'm all on this!!! I wish they also offered 1350s as well as 1310s. I'm really looking for 1350s with upcoming hemi conversion I'm about to do in mid-December.

 

You can either order with custom lengths or by telling them your current set up. They also offer the shafts in 2" x .120 DOM. The factory front flange is used with their shaft so its one less thing to have to swap on the trail if you keep your factory shaft around as a trail spare.

 

Yes. They know what length to build em by the height of your lift. But because I have a rock krawler lift that pushes the rear end back an inch they wanted measurements.

 

Sounds like a GREAT christmas present to myself...heheh I'll give them a call and see what I can get done while I'm in Texas doing my hemi conversion, thanks for the advice fellows.

 

I also have Adams Driveshafts and they are great. I am also a local to his shop and know James Adams personally, he has a great shop and an amazing crew working for him. HIs customer service is among the best. You will not be dissapointed in his work.