Alloy usa shafts
#2
#3
#4
They appear to be a good bit cheaper than other axles that has me a little hesitant. I just didn't want to save up front and spend more on another set of axles. I would like to know how they preform compared to other brands. I hope its about the same.
#5
the guys at 10 Factory used to be at Alloy - Ten Factory has had a 10yr warranty on their axle shafts since they became 10 Factory.
10 Factory appears to have better QC then others but they both make a good product and stand behind them
10 Factory appears to have better QC then others but they both make a good product and stand behind them
Last edited by jeeeep; 09-01-2013 at 03:12 PM.
#6
JK Enthusiast
Join Date: Sep 2011
Location: American Canyon, CA
Posts: 144
Likes: 0
Received 0 Likes
on
0 Posts
I have a 2012 rubicon, don't know if that makes a difference but I went back a forth with alloy USA. The right side kept leaking this is what I found
The top is the alloy usa the bottom is factory. Where the seal sits its machined smaller than the factory. They sent me 3 different sets all the same. So on the third one they refunded my money and didn't want the third set back. Now I have them sitting in my garage for over a year. Go Ten factory or RCV's
The top is the alloy usa the bottom is factory. Where the seal sits its machined smaller than the factory. They sent me 3 different sets all the same. So on the third one they refunded my money and didn't want the third set back. Now I have them sitting in my garage for over a year. Go Ten factory or RCV's
#7
JK Jedi
I have them and they have held up fine so far. Sucks the rubicon alloys dont have full circle clips. Id weld them (voids warranty) or use loctite wicking bearing retainer slip fit
Trending Topics
#9
JK Enthusiast
Join Date: Apr 2013
Location: Ottawa, ON, Canada
Posts: 359
Likes: 0
Received 0 Likes
on
0 Posts
I have a 2012 rubicon, don't know if that makes a difference but I went back a forth with alloy USA. The right side kept leaking this is what I found
<img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=494028"/>
The top is the alloy usa the bottom is factory. Where the seal sits its machined smaller than the factory. They sent me 3 different sets all the same. So on the third one they refunded my money and didn't want the third set back. Now I have them sitting in my garage for over a year. Go Ten factory or RCV's
<img src="https://www.jk-forum.com/forums/attachment.php?attachmentid=494028"/>
The top is the alloy usa the bottom is factory. Where the seal sits its machined smaller than the factory. They sent me 3 different sets all the same. So on the third one they refunded my money and didn't want the third set back. Now I have them sitting in my garage for over a year. Go Ten factory or RCV's
#10
JK Enthusiast
Join Date: Feb 2011
Location: Farmington, Utah
Posts: 198
Likes: 0
Received 0 Likes
on
0 Posts
G2's are a good option as well. I have them in my front D44. I went with them because they have a lifetime warranty. I believe they were just over 600 for the entire set.