After lift-back right sags
#1
JK Enthusiast
Thread Starter
After lift-back right sags
Just finished installing my TF 2.5" coil lift with Bilsteins and noticed the back right of my rig is about 1" lower than the back left, anyone have any suggestions as to where I went wrong. I noticed I remounted my rear trackbar on the top of the two axel mount holes, for 2.5 inches should it be in the lower of the two?
Would love to figure this out, any help is much appreciated
Would love to figure this out, any help is much appreciated
#4
I've just installed replacement coil springs off of a 4 dr on my 2 dr. When I put the rear ones in I noticed I had to twist them a bit for them to seat properly. I hope this helps. Hopefully others will chime in to give you their advice as well.
Trending Topics
#9
JK Junkie
#10
If you just put on heavier tires and a new TC that's offset to the right side of the tailgate, that in conjunction with the gas tank could possibly cause the backright to sag a little; but the tire/wheel combo would have to be pretty heavy. I noticed it ever so slightly with my 37" Toyos. Dropped the spare off the back and the slight "chevy lean" went away. B!#ch getting it back on though.