dentondanner

Install complete ~ (4.56 gears / Artec Truss) ~ Still in the break-in period but I can tell with a big smile on my face that this was the right gear for my set-up. Just a word of advice to anyone that is re-gearing ~ ensure the back seals are replaced and not re-used to prevent leakage and bearing failure. The front seals are included in a master rebuild kit but the backs are not. Your retainer plate can be re-used but I advise a new oil seal, bearing and bearing retainer on each side. Ask me how I know this? All in all minus a small hick-up the true tracs / 4.56 are in, 100% satisfied.

dentondanner

At 70mph I am at 2700 rpms, my 315/70/17 Dura Tracs measured 33.75 @ 30 psi which is what I plugged into my Flashpaq along with the gears set and a 87 performance tune.