0.75" Daystar ComfortRide Coil Spacers with 35s...
11-03-2010, 11:36 AM
#11
JK Enthusiast
Thread Starter
Join Date: Oct 2010
Location: Concrete Jungle
Posts: 306
Likes: 0
Received 0 Likes
on
0 Posts
Here's a side pic. I haven't tested it yet on the trails because I just finished yesterday evening. But I measured and I've got just as much clearance as my TeraFlex 3" lift had with stock fenders.
11-03-2010, 11:39 AM
#12
JK Enthusiast
Thread Starter
Join Date: Oct 2010
Location: Concrete Jungle
Posts: 306
Likes: 0
Received 0 Likes
on
0 Posts
11-03-2010, 11:42 AM
#13
JK Enthusiast
Thread Starter
Join Date: Oct 2010
Location: Concrete Jungle
Posts: 306
Likes: 0
Received 0 Likes
on
0 Posts
This is the kit I got, and it came with side marker light relocation brackets:
http://ruggedridgeoffroad.com/blog/h...-jeep-wrangler
wow did you mount your side markers
http://ruggedridgeoffroad.com/blog/h...-jeep-wrangler
11-03-2010, 11:57 AM
#15
JK Enthusiast
Thread Starter
Join Date: Oct 2010
Location: Concrete Jungle
Posts: 306
Likes: 0
Received 0 Likes
on
0 Posts
No... I might be able to trim them and see if they'll fit. That's my next project. Rugged Ridge mentioned that they were making some liners to go with this kit, and that was a few months ago. I've asked the Rugged Ridge vendor twice on their vendor forum this past week and sent them two PMs. They don't seem to have any interest in getting back to me, so they can pound sand. Talk about shitty customer service.
11-03-2010, 12:05 PM
#16
JK Enthusiast
Join Date: Jun 2010
Location: Jasper, IN
Posts: 321
Likes: 0
Received 0 Likes
on
0 Posts
No... I might be able to trim them and see if they'll fit. That's my next project. Rugged Ridge mentioned that they were making some liners to go with this kit, and that was a few months ago. I've asked the Rugged Ridge vendor twice on their vendor forum this past week and sent them two PMs. They don't seem to have any interest in getting back to me, so they can pound sand. Talk about shitty customer service.
11-03-2010, 12:07 PM
#17
JK Enthusiast
Join Date: Jun 2010
Location: Jasper, IN
Posts: 321
Likes: 0
Received 0 Likes
on
0 Posts
11-03-2010, 12:13 PM
#18
JK Enthusiast
Join Date: Aug 2010
Location: Reno
Posts: 401
Likes: 0
Received 0 Likes
on
0 Posts
No... I might be able to trim them and see if they'll fit. That's my next project. Rugged Ridge mentioned that they were making some liners to go with this kit, and that was a few months ago. I've asked the Rugged Ridge vendor twice on their vendor forum this past week and sent them two PMs. They don't seem to have any interest in getting back to me, so they can pound sand. Talk about shitty customer service.
