Welder in houston? I have a small welding job.
07-17-2012, 08:33 AM
#31
JK Enthusiast
Thread Starter
I'm down. I should be able to get some parts in. I would love to get c gussets welded in. Not that I expect it, but if people want to tackle an AEV 2.5" dual sport and driveshaft instal, I would love to provide the keg, and trade some of my take offs to ease the pain of significant other's wrath. Even if not this time, maybe another time.
07-17-2012, 09:42 AM
#34
JK Freak
Join Date: Apr 2010
Location: Cypress, Tx
Posts: 695
Likes: 0
Received 0 Likes
on
0 Posts
[QUOTE=bushpilot;3118562]
Yea, after getting here today and realizing how slow it is.... i should have gone.....
as for the rails, the mount locations are the same? Or are there holes in the body for them?? I figured we'd have to at least get the mount locations done, but if not, even better. It's easy to cut too. I cut a few inches off mine when i put the 35's on.
as for the rails, the mount locations are the same? Or are there holes in the body for them?? I figured we'd have to at least get the mount locations done, but if not, even better. It's easy to cut too. I cut a few inches off mine when i put the 35's on.
07-17-2012, 02:42 PM
#37
got the drill press, sawsall, grinder, jacks and jack stands...and probably enough tools to cover what's been mentioned so far.
Id suggest folks bring some spray paint (to cover the welded bits) and an old towel (for soaking and wrapping of the balljoints).
no cups needed...got that covered too.
Id suggest folks bring some spray paint (to cover the welded bits) and an old towel (for soaking and wrapping of the balljoints).
no cups needed...got that covered too.
