Off Road Evolution knuckle gusset install.

Reply Subscribe

Thread Tools

08-12-2008, 04:48 AM

#21

SASQUATCH

JK Super Freak

Join Date: Jan 2008

Location: The Deep Dark Woods of Texas!

Posts: 1,835

Likes: 0

Received 0 Likes on 0 Posts

Quote:

Originally Posted by RedneckJeep

Just wonderin, Mr. Lizard....since the deestruckshuns say to remove the ball joints so they won't be heat damaged, how did you keep yours cool? Unless you left out that part, it appears that you did not remove them.

Just a slow weld throughout, for example weld an inch at a time on drivers side(have someone cool that area with a big soaken wet rag) and then go weld on the pass side about an inch, swap back and forth like that, not bad on a creeper and a helper.go from one side to the other. Great product

Last edited by SASQUATCH; 08-13-2008 at 07:33 AM.

Reply Like

08-12-2008, 04:35 PM

#22

Screamin Lizard Customs

Sponsoring Vendor

Thread Starter

Join Date: May 2007

Location: Bedford, Texas

Posts: 1,646

Likes: 0

Received 0 Likes on 0 Posts

Thanks guys, thats just plain ole mig with 75/25% mix. The next set I might Tig with some nickel rod.

Reply Like

08-13-2008, 07:19 AM

#23

RedneckJeep

JK Jedi

Join Date: Feb 2008

Location: Georgia

Posts: 7,213

Likes: 2

Received 7 Likes on 7 Posts

Quote:

Originally Posted by SASQUATCH

Just a slow weld throughout, go from one side to the other, no more than about an inch at a time and keep it cool with a good soaked rag is all I did. Great product

Thanks. That's whut I wuz lookin fer.