My D30 build-up thread
#13
JK Super Freak
Thread Starter
Join Date: Sep 2010
Location: Maine
Posts: 1,937
Likes: 0
Received 0 Likes
on
0 Posts
No lockers and I may do shafts if money allows. I ran a poll and it looked like a vast majority of the D30's did not break as everyone seems to think, but a large majority of the failures were the u joint and axle shaft!
#14
JK Super Freak
Thread Starter
Join Date: Sep 2010
Location: Maine
Posts: 1,937
Likes: 0
Received 0 Likes
on
0 Posts
I only get a few hours a week to work o nit so it's going to take some time, but I don't mind because I wanted a winter project that would last a while. If I had the time, it would not have taken me much time at all to get it all done.
#15
JK Enthusiast
Join Date: Nov 2012
Location: Centereach, NY
Posts: 338
Likes: 0
Received 0 Likes
on
0 Posts
#18
JK Super Freak
Thread Starter
Join Date: Sep 2010
Location: Maine
Posts: 1,937
Likes: 0
Received 0 Likes
on
0 Posts
Well It's been a few days and I finished the truss. I heated up the cast section to around 300+ (it's all I could get it to with what I had). I went slow moving around from side to side and all went well.
Again, I can't state how much easier this has been to have it out of the Jeep and to be able to get to it at all angles.
Looks like the ball joints are next and to get it rust proofed!
Again, I can't state how much easier this has been to have it out of the Jeep and to be able to get to it at all angles.
Looks like the ball joints are next and to get it rust proofed!