DIY Hardtop Cart
#175
Picture and thanks
Figured I'd post and say thanks for the directions.
$40.76 mainly because I went with locking casters for all 4 wheels (note the locks on the casters might prevent the caster from rotating if you put the casters all the way to the edges).
Instead of carpet I tried the Anti-Fatigue Roll Mat #61241 from Harbor Freight. It was cheap ($9) and padded, not sure though how long it will stay fluffy, seems like the cells in the foam may collapse.
Next I'm going to throw the cross brace in it and tie it down with a strap just in case.
$40.76 mainly because I went with locking casters for all 4 wheels (note the locks on the casters might prevent the caster from rotating if you put the casters all the way to the edges).
Instead of carpet I tried the Anti-Fatigue Roll Mat #61241 from Harbor Freight. It was cheap ($9) and padded, not sure though how long it will stay fluffy, seems like the cells in the foam may collapse.
Next I'm going to throw the cross brace in it and tie it down with a strap just in case.
#177
Front Page News!
Awesome job. Thought the front page crowd would think so too...
How To Build a Jeep Hard Top Dolly - JK-Forum
How To Build a Jeep Hard Top Dolly - JK-Forum
#179
[QUOTE=smbundy13;4145939]are yall securing the top to the cart in any way?
thanks.[/QUOTE
I used a ratchet strap to secure my top to the cart. Was concerned that it may jump off if I rolled the cart while the top was on it. I placed a carpet scrap between the strap and where it touches the top and just pulled the strap till snug being careful not to over tighten. I don't have a picture of it on the cart but I think there is one somebody posted to this thread. That's where I got the idea.
thanks.[/QUOTE
I used a ratchet strap to secure my top to the cart. Was concerned that it may jump off if I rolled the cart while the top was on it. I placed a carpet scrap between the strap and where it touches the top and just pulled the strap till snug being careful not to over tighten. I don't have a picture of it on the cart but I think there is one somebody posted to this thread. That's where I got the idea.
Last edited by 2014Wrangler; 03-16-2016 at 10:37 AM.