what did I do!!!!?
#1
JK Enthusiast
Thread Starter
Join Date: Oct 2010
Location: Jacksonville, FL
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
what did I do!!!!?
Took my JK thru some trails and water.... deppest it got was to the bottom of the doors... had a great day and some awsome picks... I have to go back to the trails tomorrow to find my mbrp muffler..... Got stuck in a few feet of mud /water. Got some cool picks and had a blast! The aftermath however has been a nightmare. My JK has been overheating like crazy. First think I thought it was just the mud all over the engine.... cleaned it all up with a pressure washer, gegreased, washes the whole nine yards.... and now still At low sppeds my jeep red lines the thermostat... what did i do!? Notice the driver side fender flying off... btw my wife hates me b/c this is our only vehicle
#6
JK Enthusiast
Thread Starter
Join Date: Oct 2010
Location: Jacksonville, FL
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
fast enough to make that water double the hight of the jeep.... dumb i know.. but im sober now. and after watching two fords and a chevy get stuck I had to show off...... That puddles not the worst... I think I know where my exhaust is floating/sunk... just hope someone didnt or doesnt crush it by the time I get back tomorrow
#7
In Florida, I think mud is a lot more common than rocks... but damn, you must have hit that mud puddle at a crazy speed to knock your fender off. honestly, you're lucky you didn't hydrolock it going that fast.
Trending Topics
#8
JK Super Freak
Join Date: Mar 2008
Location: Massachusetts
Posts: 1,228
Likes: 0
Received 0 Likes
on
0 Posts
It's true. The radiator could be so clogged you'd be shocked. You may need to take the front grill piece off to power wash the radiator. There have been other threads with like stories. Good Luck
#10
JK Enthusiast
Thread Starter
Join Date: Oct 2010
Location: Jacksonville, FL
Posts: 271
Likes: 0
Received 0 Likes
on
0 Posts
As far as the fender coming off... I had my dealer perform the gas tank and fender recall this morning... I think the a-holes forgot to put on two of the clips because they are MIA and that is the side they had to take off to perform the recall