rooster1976

So any ideas on how to keep my quadratec floor mats from hovering around in the back......help

hoghd06

I roll my mopar slush mat like a sleeping bag and tuck it under the back seat

jaker t5

I cut two slits in the mat and carpet ran a zip tie trough it and done , you can hardly see the zip tie

NJ-RUBICON

Zip tie it to the front seats

skippyrock

I let mine float, its never flown away ive done prob 15-20k miles with it like that. I thought about zip ties but i get alota sand in the back and often take out the mat to empty it. I thought about velcro too but am to lazy to go buy some lol

rooster1976

Yea I would get tired of cutting zip ties........Velcro hmmmmm good idea

OH9JK

Should of got a two door and wouldn't have these problems. Tee hee

OKJK11

I went to lowes and got some snaps. Screw the male side into floor, then brad the female side to the floor mats. I think I put like six total on back mat. Simple snap in snap out process now.

PhantomRescue

Did this to my rear passenger mat, get the good industrial velcro with the tape on the back. Stick it on the top and bottom of the very end and one piece where it goes up and over the hump. It'll never move again, won't rip up the threads on your carpet and is easy to remove for cleaning.

JKGRND

A buddy of mine uses something called "mat-lock"s. They are these little metal clips that install with a pin through the carpet next to the rubber mats, then clip onto the edge of the mat, thus "locking" them to the floor. I just saw these yesterday for the first time. Not sure where to get them yet though.