JeepTerp

Installed my new hood latches in about 15 minutes.

TreyJK

I heard those are lockable somehow, do you see any way that a padlock or something could be used on them?

JeepTerp

There is not much room to get a lock on them. I tried to Google this and see if someone else has accomplished this.

GreenJK07

Finished up one tail light today.

121Ranger

Just installed the Teraflex big rotor front brake kit. It was super easy to install and I can tell a difference in stopping power. Now of course my pads were pretty worn and the new set of Hawk pads has a lot to do with it. They look pretty cool also, however, really make the rear rotors look small. If/when Teraflex comes out with same kit for the rear, I'll be the first to buy.

horrocks007

Teraflex sway bar disconnects







I had some help installing them.





And I removed my ace sliders.

eternus

Just added Rubicon Rails this weekend, planning to add Ace sliders later. Why did you remove yours?

horrocks007

After only one year the powder coating is flaking off and they have surface rust underneath. Not happy with that, but they are inexpensive and very sturdy.

I would bed-line them before you put them on. I plan to remove the powder coating, sand where needed and coat them with bed liner.

I've talked to others who have had the same problem with Ace sliders.

ThwopKing

Took it into the dealer for the trans cooler line recall and finally, after 7 months and now being almost 20k miles oit warranty, they told me that the engineers have come up with a possible fix for my massive engine noise at start up I have when its under 32 degrees.....new thermostat and coolant flush costing 330 bucks. ... even though it was diagnosed fully under warranty. Yeah total bullcrap!

nickel_13

Got my new seat covers