What was done to your JK this week?
JK Newbie
Join Date: May 2012
Location: Villa Rica, GA
Posts: 11
Likes: 0
Received 0 Likes
on
0 Posts
JK Enthusiast
Join Date: Mar 2012
Location: Sumter, SC
Posts: 336
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by gouacats
Repurposed my son's BMX peg into a Jeep foot rest. I'll flip it over because it's a bit too high as is.
JK Enthusiast
Join Date: Jul 2012
Location: Old bridge nj
Posts: 375
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by gouacats
Repurposed my son's BMX peg into a Jeep foot rest. I'll flip it over because it's a bit too high as is.
JK Enthusiast
Join Date: Jun 2012
Location: Houston texas
Posts: 149
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by Redjk777
Hey how did you mount those d rings that looks great.
JK Enthusiast
Join Date: Dec 2010
Location: Beaver County, PA
Posts: 215
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by scott franklin
Man those look great. I'm really wanting a set of these. How difficult are they to install?
Originally Posted by Redjk777
Please show how the peg is attached.
Here are the parts needed:
BMX foot peg
One 3/8 x 4 eye bolt (if I remember correctly)
Two 3/8 fender washers (I cranked these until they were dimpled to keep the eye bolt somewhat centered)
Three "normal" 3/8 washers (one inside the peg, two above and below the hinge)
One 3/8 x 1 1/2 bolt (holding eye bolt to peg)
Two 3/8 nuts (one inside peg, one on eye bolt)
Hopefully this helps. Attached is a close up.