Teraflex Leveling Pics
#42
JK Enthusiast
Thread Starter
Join Date: May 2009
Location: Charleston, SC
Posts: 181
Likes: 0
Received 0 Likes
on
0 Posts
I just added rubi coils (17/18's) to my existing leveling kit. The coil size really makes a difference.
Before:
After:
Before:
After:
Last edited by chucktownjk07; 05-06-2010 at 11:50 AM.
#46
Just installed mine
Got mine in yesterday, I used gpwpat's directions and spacers went in without any problems. 21" Floor jack and a piece of a 2x4 for extra height at the rear was high enough to do it. Leaving the wheels on saved time for sure.
I got the TF quick disconnects with the kit too, but there were no instructions for the hardware. Luckily, Project-JK has a write up on them and it was pretty similar, however I only printed the photos to have as a back up, without reading the write up. So i had one snag...
But, Dave at Northridge (answered his phone on a Sat afternoon) answered a key question about fitting the links onto the disconnect pins: "See the metal sleeves on the links? Remove them." Yep. That simple, and that did it. Thanks Dave!
If I can figure out how to post pics again I'll edit this with a few.
Before:
After:
I got the TF quick disconnects with the kit too, but there were no instructions for the hardware. Luckily, Project-JK has a write up on them and it was pretty similar, however I only printed the photos to have as a back up, without reading the write up. So i had one snag...
But, Dave at Northridge (answered his phone on a Sat afternoon) answered a key question about fitting the links onto the disconnect pins: "See the metal sleeves on the links? Remove them." Yep. That simple, and that did it. Thanks Dave!
If I can figure out how to post pics again I'll edit this with a few.
Before:
After:
Last edited by 2mont; 05-17-2010 at 09:01 PM. Reason: Photos