Show Us: Your Modified Stock Bumpers!!
#12
JK Newbie
Thread Starter
Join Date: Apr 2014
Location: Yorkville, IL
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
#14
JK Super Freak
Join Date: Jun 2011
Location: Bakersfield Kalifornia
Posts: 1,470
Likes: 0
Received 2 Likes
on
2 Posts
I used the Shittybilt JK winch plate. It's pretty rugged but it was a bitch to install as a bunch of the bolt holes didn't line up and I had to pry and grind to get everything to line up. Its held up well though.
#15
#16
JK Junkie
Join Date: Jul 2011
Location: Fenwick Island, Delaware
Posts: 2,171
Likes: 0
Received 0 Likes
on
0 Posts
Modified stock bumper.... Painted appliqué, MBRP light bar with 10in rigid light, VDP high clearance end caps. I like it, but honestly replacing all of it with a MBRP bumper as soon as FedEx delivers it!
#17
JK Newbie
Thread Starter
Join Date: Apr 2014
Location: Yorkville, IL
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
Haha! Sounds like loads of fun! I usually go the cheap route and everytime I end up wishing I spent the extra $$ and not deal with the headache.
#18
JK Newbie
Thread Starter
Join Date: Apr 2014
Location: Yorkville, IL
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
This has got to be one of the best modified stock bumpers I have seen yet! Very well done!
Last edited by JKano; 05-05-2014 at 01:51 PM.
#19
Didn't see this message till now ....
I got a plate made , forget the dimensions exactly but went with sizes I needed, and shop bent and cut for me I just had to drill holes cut for fairlead and trim slightly where it wrapped over top of frame. Was cheap I thought 30$ or so and I used a grinding wheel and broke a drill bit or two.
#20
JK Newbie
Join Date: Apr 2014
Location: Panama City Beach, FL
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
https://www.youtube.com/watch?v=WjFaeBJq_zg
running water in the rear ... pressurized with a pump tapped into the bumper