Paracord wrap
11-08-2011, 01:33 PM
#21
JK Super Freak
Thread Starter
depending on how tight you make the knotwork it shouldnt stretch much if any at all....550 paracord is parachute cord, if it stretched that wouldnt be to safe lol. the stretching of grab handles with this would be more along the lines of the two parts that tie to the roll bar coming closer together while pulling. this could be avoided by putting something stiff inbetween then on the top of the rollbar where you dont see it. that would help avoid. I havnt done handles, I have the mobar ones....I might make some now though haha
11-09-2011, 05:00 AM
#23
JK Enthusiast
Join Date: Aug 2010
Location: Phoenix, AZ
Posts: 111
Likes: 0
Received 0 Likes
on
0 Posts
11-09-2011, 08:17 AM
#26
JK Super Freak
Thread Starter
you can do it many different ways, I just always start with a cobra knot for the first knot, is hard as it wants to move but once you get a couple down it holds tight.
11-10-2011, 12:23 AM
#30
JK Freak
Join Date: Aug 2011
Location: Cheyenne Wyoming
Posts: 656
Likes: 0
Received 0 Likes
on
0 Posts
Not very well I am Afraid. 
It stays but it is a large knot on the left hand side on the back of the wheel. I kind of over did it so it wouldnt come undone. I will probably go back ang fix it to a slimmer tougher knot. Just as soon as I can figure one out
It stays but it is a large knot on the left hand side on the back of the wheel. I kind of over did it so it wouldnt come undone. I will probably go back ang fix it to a slimmer tougher knot. Just as soon as I can figure one out