dfav000

Chopped the bumper. Added molar light bar and two hella lights. I think it came out ok.




Sb

bobbyspaghetti

I agree it did come out nice. Good job.

texwillys

Looks great!

Jtrain496

Nice job. Looks good.

FoxRacingJMC

Came out good my friend, good job. Now that you saved the money you would have spent on the bumper, fab up a winch plate and get a winch on that bad boy!

dfav000

Yeah I def want to do that. Need to do some reading up on that. Does the winch go inside the bumper?

FoxRacingJMC

Do some searching on here for DIY stock winch plates, there are a bunch of threads. But yes, its supported by the frame studs and the metal part of your bumper. It sits lower that the plastic bumper(but looks good). More of a recessed look.... Again, do a search...you'll find lots of tips/photos, etc.

MacBeJeepin

Looks sweet. I'm chopping up my bumper this weekend. Where'd you get the light bar from? I'm looking to add a bar as well, and I'm looking for some options.

dfav000

Thanks alot.
I got it from amazon. Mopar light bar for jeep. I think it was about 60 bucks or so and then the light were about the same. Good luck. Best advice I have is get a good saws-all and a dremmel. you can trim just enough to gt the endcaps to fit perfect.

dfav000

Thanks everyone. Im loving my new jeep. I have a 2.5 RC lift in the garage been dreading to do. Anyone want to come give a hand in SW Florida???