My first fabricaton attempt!
#1
JK Freak
Thread Starter
Join Date: Sep 2011
Location: Casper, WY
Posts: 835
Likes: 0
Received 0 Likes
on
0 Posts
#2
I finally started cracking on my front bumper as well. I havent stubbied it yet because i dont have an angle grinder yet, but i will pick one up soon. I also cut off the crush cans and patched all the little holes in the bumper with JB weld. It looks much nicer that way. Hurry up and tell us about phase two
#3
JK Freak
Thread Starter
Join Date: Sep 2011
Location: Casper, WY
Posts: 835
Likes: 0
Received 0 Likes
on
0 Posts
Lmfao! Well I decided to keep the cans, paint them body color to match and use them to hold my tow strap. New bolts to replace the factory bolt straps, and grill mod the bumper openings(maybe the factory silver) until I get some figs to throw in. Any idea what the wiring running in the bumper is?
Trending Topics
#8
JK Freak
Thread Starter
Join Date: Sep 2011
Location: Casper, WY
Posts: 835
Likes: 0
Received 0 Likes
on
0 Posts
Ok. Done for now...and here's my take. I dig it short term. Way more aggressive and creative than stock, but not perfect. I like the custom look and I literally spent $14.78. Granted I already had the silver paint and mesh on hand for some interior upgrades and the grill mod that I haven't done yet. What do you all think... Tear it up!
#9
JK Freak
Thread Starter
Join Date: Sep 2011
Location: Casper, WY
Posts: 835
Likes: 0
Received 0 Likes
on
0 Posts
Oh, and the cans will most likely be covered by my tow strap. I think I am going to put the loop around one can and wrap it figure 8 and then tie it off.