my 57 Dollar bumper (including paint)
11-18-2010, 03:38 PM
#1
JK Enthusiast
Thread Starter
Join Date: Sep 2010
Location: Grande Prairie, AB
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
my 57 Dollar bumper (including paint)
Hey Im new here and I see alot of people are building bumpers so I thought I`d share mine. Hit a deer this morning so I built this this afternoon.
I only had a couple hours to work on it, I still need to put my factory driving lights back in and build a Light bar once my tube bender comes in.
I only had a couple hours to work on it, I still need to put my factory driving lights back in and build a Light bar once my tube bender comes in.
11-18-2010, 03:43 PM
#2
JK Enthusiast
Join Date: May 2008
Location: San Antonio, Tx
Posts: 164
Likes: 0
Received 0 Likes
on
0 Posts
looks nice. what did u use? c channel? im gonna make my own this coming summer and been trying to get ideas. I actually like the factory stock bumper, so im thinking just replicate it bt with steel and a midwidth. so the length is actually measured 1/2 the width of the tire or from rotor to rotor length. bt idk yet. just a thought. i really like shrock works midwidth bumper
11-18-2010, 03:45 PM
#3
JK Super Freak
Join Date: Oct 2008
Location: Sussex County, NJ
Posts: 1,415
Likes: 0
Received 0 Likes
on
0 Posts
Hey Im new here and I see alot of people are building bumpers so I thought I`d share mine. Hit a deer this morning so I built this this afternoon.Attachment 103211Attachment 103212Attachment 103213
I only had a couple hours to work on it, I still need to put my factory driving lights back in and build a Light bar once my tube bender comes in.
I only had a couple hours to work on it, I still need to put my factory driving lights back in and build a Light bar once my tube bender comes in.
Good Job
11-18-2010, 03:48 PM
#4
JK Enthusiast
Thread Starter
Join Date: Sep 2010
Location: Grande Prairie, AB
Posts: 129
Likes: 0
Received 0 Likes
on
0 Posts
Thanks guys!
I used 6x6x3/16" square tubing, and 3 and 4" - 3/16" flat bar. C channel has to square of an edge for my liking, I used the box tubing for the top and front to give a nice radius edge and less welding.
I used 6x6x3/16" square tubing, and 3 and 4" - 3/16" flat bar. C channel has to square of an edge for my liking, I used the box tubing for the top and front to give a nice radius edge and less welding.
