MIG Welding plate
#11
JK Newbie
Join Date: Dec 2011
Location: Bethlehem, PA
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
I have a Miller 185 at work that has no problem burning into 1/2 steel with 75/25 gas mix. I've also used 100% argon at times with good results. Just not good for any overhead welding.
#12
JK Freak
Thread Starter
Thanks guys! I think I'll try this out tomorrow on some scrap I have laying around. I found some angle iron I can use with some c clamps to keep the parts at 90 degree angles to each other while I get it all tacked into place. This is kinda funny but I think I'm gonna see if my new rotozip cutter will cut plate...just to see if it will.