Edisco manual mod complete
07-03-2011, 09:53 AM
#1
JK Freak
Thread Starter
Join Date: Jan 2011
Location: Poway, California
Posts: 761
Likes: 0
Received 0 Likes
on
0 Posts
Edisco manual mod complete
Here are pic's of the modification I did using hardware from my parts bins. A half an hour with the cutoff wheel, grinder and MIG and this is what I came up with. Not the prettiest but quite functional and zero $ out of pocket. Also did the "flip" at the same time. I'll take some pic's of it installed along with the bracket I made to hold the Edisco in place since I didn't get the rubber bushing when I bought the Edisco.
... first time posting pictures
07-03-2011, 11:01 AM
#3
Hats-off to you and your ingenuity.
For those of you that don't have the tool's there's this
https://www.jk-forum.com/forums/show...bar+Disconnect
For those of you that don't have the tool's there's this
https://www.jk-forum.com/forums/show...bar+Disconnect
07-03-2011, 01:09 PM
#4
JK Freak
Thread Starter
Join Date: Jan 2011
Location: Poway, California
Posts: 761
Likes: 0
Received 0 Likes
on
0 Posts
Thanks 
Funding a 401K so I have to be creative where I can to save a buck 
and still allow me to enjoy the outdoors with my family & friends 
Funding a 401K so I have to be creative where I can to save a buck and still allow me to enjoy the outdoors with my family & friends Hats-off to you and your ingenuity.
For those of you that don't have the tool's there's this
https://www.jk-forum.com/forums/show...bar+Disconnect
For those of you that don't have the tool's there's this
https://www.jk-forum.com/forums/show...bar+Disconnect
