mygig problems after firmware update.
#1
JK Enthusiast
Thread Starter
Join Date: Jul 2008
Location: Pittsburgh
Posts: 118
Likes: 0
Received 0 Likes
on
0 Posts
mygig problems after firmware update.
For the past month or two the mygig won't turn on when I start the vehicle. It can take anywhere from 5-30 minutes of drive time before it comes on. If I push the open/close button the "Jeep" logo will appear and all the buttons will light up for approximately 30 seconds, then the mygig will go dark again.
I read about completing the firmware update. Just updated to the latest version. The mygig still will not turn on right away. Since doing the update it still takes approximately 5-10 minutes to load and turn on.
Any ideas what could be causing this?
I do have a lockpick. The lockpick has been installed on the mygig for about two years with no problems until now.
Any help would be appreciated.
I read about completing the firmware update. Just updated to the latest version. The mygig still will not turn on right away. Since doing the update it still takes approximately 5-10 minutes to load and turn on.
Any ideas what could be causing this?
I do have a lockpick. The lockpick has been installed on the mygig for about two years with no problems until now.
Any help would be appreciated.