Widow

I've heard there's a relay you can change out instead of using resistors on led turn signals. Is this true and if so does anyone have any info? I have LED's now and they flash fast but I'm installing River Raider full corners this weekend and new taillights. I'd like to fix this issue. Any info would be greatly appreciated.


2007 2 door Sahara, Sprintex supercharger, King coilovers in front, 3.5" RE lift rear, full cage, Tom Woods shafts, Synergy sleeves and gussets, 4.88's, RR front bumper, Evo d rings rear, buncha other stuff too lol. 2014 JKU Sahara as well

ronjenx

The JK blinkers have no relay, so there is no relay to change out.
The load the computer sees has to be increased.

Widow

Ok is there a way to do that? Electronics aren't my thing.


2007 2 door Sahara, Sprintex supercharger, King coilovers in front, 3.5" RE lift rear, full cage, Tom Woods shafts, Synergy sleeves and gussets, 4.88's, RR front bumper, Evo d rings rear, buncha other stuff too lol. 2014 JKU Sahara as well

ronjenx

Add the resistors.

Widow

I didn't wanna go that route if there was another way. Anyone know the right way to wire in the resistors? I have a diagram from Rockridge for my other led's but it's not right. When I wired them in they stopped working.


2007 2 door Sahara, Sprintex supercharger, King coilovers in front, 3.5" RE lift rear, full cage, Tom Woods shafts, Synergy sleeves and gussets, 4.88's, RR front bumper, Evo d rings rear, buncha other stuff too lol. 2014 JKU Sahara as well