Do you wire winch direct to battery?
#1
JK Freak
Thread Starter
Do you wire winch direct to battery?
I just installed my new bumper and Smittybilt Gen 2 X2O winch and the instructions tell you to ruin direct from the solenoid box to the battery, so I did. Today, a guy at work tells me that you can not do this and that my battery will die from constant drain.
What's the real deal, are most people implementing some custom cut out solenoid with a dash switch, or are the majority doing as I did and simply following the instructions and finding it to be trouble free?
What's the real deal, are most people implementing some custom cut out solenoid with a dash switch, or are the majority doing as I did and simply following the instructions and finding it to be trouble free?
#3
Look at the current rating on your alternator and battery... then look at the draw from the winch. It should be pretty easy for the lay person to figure out.
As described in your winch manual and echoed by the previous poster, I think you should take advice from this co worker with a grain of salt.
As described in your winch manual and echoed by the previous poster, I think you should take advice from this co worker with a grain of salt.
#4
JK Enthusiast
Join Date: Feb 2011
Location: Camp Pendleton, CA
Posts: 313
Likes: 0
Received 0 Likes
on
0 Posts
There shouldn't be a drain on the battery unless the winch is being used. I have mine connected straight to the battery, but leave the wireless control unplugged to ensure there is no way the winch will use the power. I have never had a problem with this. You can however connect a safety cutoff switch/solenoid to connect and disconnect power for peace of mind.
#5
JK Super Freak
Join Date: Oct 2009
Location: 54° 4.5' N 123° 7' W
Posts: 1,605
Likes: 0
Received 0 Likes
on
0 Posts
Unless you have bad wiring in your winch solenoid you should have zero drain. I only plug in the controller when I need it, and am wired straight to the battery.
#6
JK Enthusiast
Mine is wired direct to the battery, but I know people who have an intermediate solenoid wired in.
Sounds like a good subject for a poll, direct vs. indirect.
Sounds like a good subject for a poll, direct vs. indirect.
Trending Topics
#8
I just hooked up my first winch.... My Buddy was concerned that the stock terminals were too light.... I hooked up without any problems so far.... I think I will add heavier terminals at some point.... But for now.... right to the battery with no issues....
#9
The manual disconnects should be installed as close to the battery terminal as possible and are used as a safety mechanism, not really to remove any theoretical idle current draw. For example, if the vehicle is involved in a crash that severs the positive battery cable and it touches the metal frame/body, ugly stuff can happen. As well, although less likely, if there is an internal problem with the winch and it shorts out.
#10
The manual disconnects should be installed as close to the battery terminal as possible and are used as a safety mechanism, not really to remove any theoretical idle current draw. For example, if the vehicle is involved in a crash that severs the positive battery cable and it touches the metal frame/body, ugly stuff can happen. As well, although less likely, if there is an internal problem with the winch and it shorts out.
Probably a better (unfortunately more expensive as well), would be a high current fuse set inline with the winch positive laid close to the positive connection to power. Running a disconnect would either mean it would be useless or you'd create the need for the disconnect with the extra long positive lead. Both issues are due to placement. Seems silly to create a problem when none exists.