Hey guys, just did this MOD on my 08’.

I used a 3 prong LED on/off toggle switch.

I cut the violet/light blue wire and placed the switch between my 4wd and shifter.

I wired the line from the front of the vehicle to the “power” tab, the line to the rear of the Jeep to the “load” or center tab, and spliced a ground from the accessory port to the “ground” tab.

All works well except even when the circuit has been closed and the power to the Jeep cycled the ESP and Jeep with squiggly lines remains but the ABS light is off....

What’s going on here??