2007 Built JKU on 37's (Phx, AZ)
12-10-2012, 02:02 PM
#1
JK Freak
Thread Starter
2007 Built JKU on 37's (Phx, AZ)
2007 Jeep JK Unlimited Rubicon
Auto trans. Roughly 95k miles. Was built and used as a capable rock crawler. It has wheeled from Table Mesa to Florence Junction to Moab to Johnson Valley. It has been used but not abused. This rig will take on all but the hardest trails, and is still decent on the street. It could use a little love right now to get it back to perfect condition, but is still a nice Jeep. This was the corporate Jeep for HIDX Offroad Lighting, and sat in the booths of several national trade shows over the years. However, if you are looking for a pretty show rig, this is not for you. If you are looking for a well-respected rig that has been there done that, and will do it again... this will serve your purpose.
PRICE:
Jeep needs some love right now. If it was dialed in, and some of the little issues resolved, it should sell for between $23-25,000. Will sell for $18,900 as is where is. Good investment for a wrench who wants to flip it. Great deal for somebody who wants a high quality, built rig at a discounted price. Call or text Jason to discuss... 48o-23six-4I29. Located in Phoenix, AZ.
SUSPENSION:
Teraflex Elite LCG 6" Long Arm lift with 9550 shocks
Teraflex SpeedBumps front and rear
Rock Krawler Heavy Duty Lower Control Arm Mounts
STEERING:
Rock Krawler Heavy Duty Drag Link flip kit
Rock Krawler Heavy Duty Track Bar and Bracket
Rock Krawler Heavy Duty Tie Rod
PSC Extreme Duty Cylinder Hydro Assist Steering
DRIVETRAIN:
Teraflex CV style drive shafts front and rear
Teraflex Front axle sleeves and gussets
Yukon/Randy's Ring and Pinion 5.38 gears
RCV Performance CV Joint Front Axle Shafts
ENGINE:
Stock 3.8l V6
Airraid Intake
Flowmaster Super 44 relocated
AEV Procal programmer
WHEELS/TIRES:
KMC XD Series Hoss wheels, 17"x9"
4xIron Custom steel rock rings
Goodyear Tires MTR Kevlar 37"x12.5"
BUMPERS:
Mall Crawler Fabrication Custom front and rear bumpers
Or-Fab Swing Away Tire/Can Carrier
Smittybilt XRC8 Winch with synthetic line
ARMOR/PROTECTION:
AEV Rear Corner Guards
Riddler Front Diff cover
ARB Rear Diff cover
4xIron Custom steel rocker panel protection, B-pillar protection
ELECTRICAL/MISC:
HIDX Lights- two 4" on bumper
HIDX Lights- two 7" on windshield mouts
HIDX License Plate relocate kit/LED light
HIDX Antenna relocate kit
Optima Battery (less than 1 year old)
Cobra 75 CB
Firestick antenna
TOPS:
Jeep Hardtop
Bestop bikini top
Bestop dust cover
Bestop trail cover
SPARES/PARTS:
LOTS of spares/parts/extras to include hi-lift jack, axle shafts, drive shafts, old springs/shocks, stock air filter box, stock third brake light, etc.
THE HONEY DO LIST:
Cracked exhaust manifolds
Needs bushing on Teraflex control arm
Couple of dash lights on
Shimmy/vibe from 20-45mph
Some scratches, dents and dings
Gear oil needs replaced, diffs sealed
Oil leak (timing cover or intake manifold?)
Auto trans. Roughly 95k miles. Was built and used as a capable rock crawler. It has wheeled from Table Mesa to Florence Junction to Moab to Johnson Valley. It has been used but not abused. This rig will take on all but the hardest trails, and is still decent on the street. It could use a little love right now to get it back to perfect condition, but is still a nice Jeep. This was the corporate Jeep for HIDX Offroad Lighting, and sat in the booths of several national trade shows over the years. However, if you are looking for a pretty show rig, this is not for you. If you are looking for a well-respected rig that has been there done that, and will do it again... this will serve your purpose.
PRICE:
Jeep needs some love right now. If it was dialed in, and some of the little issues resolved, it should sell for between $23-25,000. Will sell for $18,900 as is where is. Good investment for a wrench who wants to flip it. Great deal for somebody who wants a high quality, built rig at a discounted price. Call or text Jason to discuss... 48o-23six-4I29. Located in Phoenix, AZ.
SUSPENSION:
Teraflex Elite LCG 6" Long Arm lift with 9550 shocks
Teraflex SpeedBumps front and rear
Rock Krawler Heavy Duty Lower Control Arm Mounts
STEERING:
Rock Krawler Heavy Duty Drag Link flip kit
Rock Krawler Heavy Duty Track Bar and Bracket
Rock Krawler Heavy Duty Tie Rod
PSC Extreme Duty Cylinder Hydro Assist Steering
DRIVETRAIN:
Teraflex CV style drive shafts front and rear
Teraflex Front axle sleeves and gussets
Yukon/Randy's Ring and Pinion 5.38 gears
RCV Performance CV Joint Front Axle Shafts
ENGINE:
Stock 3.8l V6
Airraid Intake
Flowmaster Super 44 relocated
AEV Procal programmer
WHEELS/TIRES:
KMC XD Series Hoss wheels, 17"x9"
4xIron Custom steel rock rings
Goodyear Tires MTR Kevlar 37"x12.5"
BUMPERS:
Mall Crawler Fabrication Custom front and rear bumpers
Or-Fab Swing Away Tire/Can Carrier
Smittybilt XRC8 Winch with synthetic line
ARMOR/PROTECTION:
AEV Rear Corner Guards
Riddler Front Diff cover
ARB Rear Diff cover
4xIron Custom steel rocker panel protection, B-pillar protection
ELECTRICAL/MISC:
HIDX Lights- two 4" on bumper
HIDX Lights- two 7" on windshield mouts
HIDX License Plate relocate kit/LED light
HIDX Antenna relocate kit
Optima Battery (less than 1 year old)
Cobra 75 CB
Firestick antenna
TOPS:
Jeep Hardtop
Bestop bikini top
Bestop dust cover
Bestop trail cover
SPARES/PARTS:
LOTS of spares/parts/extras to include hi-lift jack, axle shafts, drive shafts, old springs/shocks, stock air filter box, stock third brake light, etc.
THE HONEY DO LIST:
Cracked exhaust manifolds
Needs bushing on Teraflex control arm
Couple of dash lights on
Shimmy/vibe from 20-45mph
Some scratches, dents and dings
Gear oil needs replaced, diffs sealed
Oil leak (timing cover or intake manifold?)
