i can do Saturday at 2:30 pm

 

Sorry for not posting back sooner, got things to do in the afternoon so I am only open for the later hours.

Maybe if we look at some time a couple of weeks ahead here it will work better.

Good to meet you Brother Ika in Windsor on Thursday

Bob

 

Good to meet you also. I didn't see any reply post by saturday at noon so I figured it was cancelled. That would work better.

take care

 

Sorry gents but I had to make a run to Oshawa Sat and Sun and I couldn't post up either. I may be able to do this Sat but still can't be sure til then.

 

May I come too???

i will subscribe to thread.

keep us posted

 

Probably planning before the week of the meet will yield better results.

If it's successful, perhaps we can organize a run to Bundy Hill sometime later in the spring/summer...

 

I agree that we plan out a week or so in advance. And yes everyone in the area is welcome

My intent was to get a group and make different runs to areas that will let us put some testing on our rigs. I went on a run with the EOTB last year and had a blast.

I will look at the next couple of weeks and throw out some dates.

 

sounds like a good plan. i think i'm going to be looking at tearing the hard top off this weekend maybe. hope the soft top install isn't a giant pita.
subscribed to the thread.

 

alright then. look forward to planning something.

take care

 

Sounds great! With Morton closed down, there isn't anywhere to go for a "quick spin", and travelling in groups to places like Mounds or Bundy Hill is much smarter in case you get stuck.

Also, in regards to the soft top installation, the first time will be harder than all the others, because you have to refer to the instructions the whole time, and stretching your soft top out for the first time can take a bit of muscle. I usually wait until April to make sure there won't be any last snow showers...

Good luck!